Toshiba 37AV52U - Manual (Page 33)

Chapter 5: Setting up your TV

Viewing the digital signal meter
You can view the digital signal meter in the ANT/CABLE
digital TV input source only.
To view the digital signal meter:
Press and open the
Setup menu.
Highlight
Installation and press .
A new set of Installation menu icons will appear, as
shown below. Open the
Terrestrial menu, highlight
Signal Meter, and press .
Press pqtu to select the antenna input and digital
channel whose signal you want to check.
Note:
The physical digital channel number listed in the
Signal Meter screen may not correspond to a virtual
TV channel number. Contact your local broadcasters
to obtain the RF channel numbers for your local digital
stations.
The signal strength does not change between virtual
channels on the same physical channel.
To close the screen and return to the Terrestrial
menu:
Highlight
Done and press .
To return to normal viewing:
Press .
Setting the time zone
The Time Zone setup will allow you to specify the correct
time zone for your region. This feature will allow the TV
status information to show the correct time zone information
( page 50).
To set the time zone:
From the
Setup menu, highlight Installation and press .
A new set of Installation menu icons will appear.
Highlight
Time Zone Setup, and press .
Press p or q to select the region, highlight
Done, and
then press .
After the time zone has been set, you will be asked to set the
current Daylight Saving Time status.
To set the Daylight Saving Time status:
Press t or u to select
Yes or No, highlight Done, and then
press .
1�
2�
3�
4�
•
•
1�
2�
3�
1�
Viewing the system status
To view the system status:
Press and open the
Setup menu.
Highlight
Installation and press .
A new set of Installation menu icons will appear, as
shown below. Open the
System Status menu, highlight
System Information, and press .
Press tu to scroll through the menu bar to select the
Software Version and view the related information.
To close the screen and return to the Installation
menu:
Highlight
Done and press .
To return to normal viewing:
Press .
Reset Factory Defaults
To reset all settings and channels to their factory
default values:
Press and open the
Setup menu.
Highlight
Installation and press . A new set of
Installation menu icons will appear.
Open the
System Status menu, highlight System
Information, and press .
Press tu to scroll through the menu bar to select
Factory Defaults.
Enter your PIN code (or 0000 if no PIN code has been set).
Highlight
Yes and press . The TV will turn off
automatically after a few seconds. After the TV turns off,
unplug the TV power cord and then plug it in again to
complete the reset process.
To cancel the reset:
Highlight
No and press .
1�
2�
3�
4�
1�
2�
3�
4�
5�
6�