Texas Instruments DM648 DSP - Manual (Page 22)

www.ti.com
0 1 2 3 M Bank 0
Row 0
Row 1
Row 2
Row N
C
o
l l
C
o
l
C
o
l
C
o
Row 0
Row N
Row 1
Row 2
C C
Bank 1
l l
0 2 1
o o
C C
l l
3 M
o o
Row 0
Row N
Row 1
Row 2
C C
Bank 2
l l
0 2 1
o o
l l l l
Row N
Row 2
Row 0
Row 1
Bank P 0 1 2 3 M
C C
l l
3 M
o o
o
C
o
C
o
C
o
C
2.7 DDR2 Memory Controller Interface
Peripheral Architecture
Figure 14. DDR2 SDRAM Column, Row, and Bank Access
A M is number of columns (as determined by PAGESIZE) minus 1, P is number of banks (as determined by IBANK)
minus 1, and N is number of rows (as determined by both PAGESIZE and IBANK) minus 1.
To move data efficiently from on-chip resources to external DDR2 SDRAM device, the DDR2 memory
controller makes use of a command FIFO, a write FIFO, a read FIFO, and command and data schedulers.
Table 6 describes the purpose of each FIFO.
Figure 15 shows the block diagram of the DDR2 memory controller FIFOs. Commands, write data, and
read data arrive at the DDR2 memory controller parallel to each other. The same peripheral bus is used to
write and read data from external memory as well as internal memory-mapped registers.
Table 6. DDR2 Memory Controller FIFO Description
Depth (64-Bit
FIFO Description Doublewords)
Command Stores all commands coming from on-chip requesters 7
Write Stores write data coming from on-chip requesters to 11
memory
Read Stores read data coming from memory to on-chip 17
requesters
DSP DDR2 Memory Controller 22 SPRUEK5A – October 2007
Submit Documentation Feedback