Toshiba Programmable Logic Controller V200 - Manual (Page 68)

Page 60
Steps to lock the expansion module with the base V200
FIG-1 FIG-2 FIG-3
FIG-1 Lock connector provided with V200
PLC
FIG-2 Two slots to grip the locking connector
are provided on the case highlighted by
RED circle. Insert a big leg of locking
connector highlighted by RED rectangle.
FIG-3 Single V200 PLC with locking
connector
FIG-4 Locking connector helps the two units
(V200 base &/or V200 expansion)
to hold each-other properly on the DIN
rail plate along with DIN rail slider.
Note: Apart from these lockings, also expansion connec-
tor is present to each V200 PLC. User can connect V200
base to expansion unit using this connector. Also user
can
add more expansions to the unit with this connector only.
FIG-4