Toshiba 26AV502RZ - Manual (Page 22)

Chapter 3: Using the remote control
22
Using the remote control to
control your other devices
If you have a non-Toshiba device or a Toshiba device that
the remote control is not preprogrammed to operate, you
must first program the remote control to recognize the
device (if you have not already done so) ( pages 24–26).
To use your TV remote control to operate a:
•
Cable converter box or satellite receiver, set the
MODE SELECT switch to CABLE/SAT.
• VCR, set the MODE SELECT switch to AUX 1.
• DVD player or HTIB, set the MODE SELECT
switch to AUX 2.
Note: Even after the TV remote control is
programmed, it may not operate certain
features on any other devices. If this happens
and you wish to use those features, you will
need to use the device’s original remote control.
16
17
19
18
Point the remote control
directly at the device.
1無 POWER Turns the selected device on and off.
2無 Channel Numbers (0-9) Press to directly access
channels (as opposed to ).
3無 +10 Press to directly access DVD chapters higher than
10.
4無 TOP MENU Accesses a DVD’s top menu.
5無 CH pq For channels programmed into the channel
memory ( page 30):
p selects the next higher channel.
q selects the next lower channel.
6無 GUIDE Displays the channel guide in the CABLE/
SAT mode.
SET UP Accesses a DVD’s setup menu in the AUX
mode.
7無 INFO Displays TV status information on-screen.
8無 pqtu Press to navigate DVD menus (may not work
on some DVD players).
9無 ENTER Required by some satellite receivers and DVD
players to activate certain functions.
10無 DVD CLEAR Press to reset the title and chapter
number.
11無 PLAY Begins playback of a tape or DVD.
12無 PAUSE Press during play or record mode to pause the
picture; press again to restart.
13無 STOP Stops the tape or DVD.
14無 SKIP
Skips forward to locate later DVD chapters.
15無 FF Fast-forwards the tape or DVD. (Press during play
mode to view the picture moving rapidly forward.)
16無 SKIP Skips back to beginning of current DVD
chapter, or locates previous chapters.
17無 REW Rewinds/reverses the tape or DVD. (Press
during play mode to view the picture moving rapidly
backward.)
18無 TV/VCR To view one program while recording
another, press to select TV mode.
SEARCH selects a specific DVD chapter, title or time.
19無 REC Starts tape recording.
20無 MODE SELECT switch Set to “TV” to control
the TV; “CABLE/SAT” to control a cable converter
box or satellite receiver; “AUX 1” to control a VCR;
“AUX 2” to control a DVD player or HTIB.