Toshiba 26AV502RZ - Manual (Page 24)

Chapter 3: Using the remote control
24
REMOTE CONTROL
KEY
Toshiba TV CABLE SAT (satellite) AUX 1
(VCR)
AUX 2 (DVD or
HTIB)
REC REC MENU* --- ---
Record (2
click)
---
SLOW – SLOW REW* --- --- --- ---
SLOW + SLOW FWD* --- --- --- ---
ANGLE Angle* --- --- --- DVD Angle
SUB TITLE Sub title* --- --- --- DVD Sub title
AUDIO Audio* --- --- --- DVD Audio
EJECT Eject* --- --- --- DVD Eject
Note:
• In addition to POWER, confirm that all
necessary keys on the TV remote control
operate your device. If some keys are not
operational, repeat the device code setup
using another code (if other codes are listed
for your device). If, after trying all listed
codes, the necessary keys do not operate
your device, use the device’s original remote
control.
• Every time you change the batteries, you will need
to reprogram the remote control.
• Some newer VCRs respond to either of two codes.
These VCRs have a switch labeled “VCR1/VCR2.”
If your VCR has this kind of switch and does not
respond to the codes for your VCR brand, set the
switch to the other position (“VCR1” or “VCR2”)
and reprogram the remote control.
Programming the remote control
to control your other devices
Your Toshiba TV remote control is preprogrammed
to operate most Toshiba devices. To program your
TV remote control to operate a non-Toshiba device
(or a Toshiba device that it is not preprogrammed to
operate), follow the steps below. For details on using
the remote control to operate the device, see page 22.
1無 In the remote control code table ( page 25), find the
code for your device. If more than one code is listed,
try each one separately until you find one that works.
2無 Set the MODE SELECT switch to the type of device
you are programming the remote control to operate —
CABLE/SAT (for a cable converter box or satellite
receiver), AUX 1 (for a VCR or TV/VCR combo), or
AUX 2 (for a DVD player or HTIB [home theater in a
box]).
3無 While holding down , press the Channel Number
buttons to enter the 3-digit code for your device.
4無 To test the code, turn on the device, point the remote
control at it, and press . See notes below.
• If the correct code was entered, the device will turn
off.
• If the device does not respond, repeat steps 1–4 using
another code.
• If the device does not respond to another code, you
will need to use the remote control that came with the
device.
5無 Remember to set the MODE SELECT switch back to
“TV” to control the TV.
6無 For future reference, write down the code(s) you used:
DEVICE CODE DEVICE CODE