Toshiba 26AV502RZ - Manual (Page 6)

6
6) VESA Mounting Pattern
TV Size Hole Pattern(VxH) Screw Size
26” 100x200 mm M4
32” 200x200 mm M6
(unit in mm)
Removing the Pedestal Stand
1) Carefully lay the front of the unit face down on a flat,
cushioned surface such as a quilt or blanket. Leave
the stand protruding over the edge of the surface.
Note:
Extreme care should always be used when
removing the pedestal stand to avoid damage to
the LCD panel.
2) Remove the four screws shown in the right diagram.
This will allow removal of the pedestal stand.
3) Once you have removed all four screws, holding the
pedestal stand in place, remove the pedestal stand
from the TV.
CAUTION: Always place the TV on the floor or a sturdy,
level, stable surface that can support the weight of
the unit. To secure the TV, use a sturdy strap from
the hook(s) on the rear of the TV to a wall stud, pillar,
or other immovable structure. Make sure the strap is
tight, secure, and parallel to the floor.
Four screws
26” TV
VESA Mounting Pattern
Hook
Sturdy strap
(as short as possible)
Four screws
32” TV
VESA Mounting Pattern
Hook
Sturdy strap
(as short as possible)