Toshiba MK6017MAP User Manual
Page 75
360014937
Copyright © 2000 Toshiba corporation. All rights reserved.
-
575 -
Table 10.8-2 Identify Information (Continued)
WORD
DESCRIPTION
Hex.
57-58
Current capacity in sectors
(Number of current cylinders * Number of current heads * Number of current
sectors per track)
XXXX
59
15-9 Reserved
8 1=Multiple sector setting is valid
7-0 XXh=Current setting for number of sectors that can be transferred per
interrupt on R/W Multiple command
01XX
60-61
Total number of user addressable sectors (LBA mode only)
[5*]
62
15-8 Single word DMA transfer mode active
11
7-0 Single word DMA transfer mode supported
14
XX07
63
15-8 Multiword DMA transfer mode active
7-0 Multiword DMA transfer mode supported
XX07
64
15-8 reserved
7-0 Advanced PIO Transfer Modes Supported
bit 7-2 Reserved
bit 1 = 1 PIO MODE 4 supported
bit 0 = 1 PIO MODE 3 supported
0003
65
Minimum Multiword DMA Transfer Cycle Time Per Word (ns)
0078
66
Manufacturer’s Recommended Multiword DMA Transfer Cycle Time
0078
67
Minimum PIO Transfer Cycle Time Without Flow Control (ns)
0078
68
Minimum PIO Transfer Cycle Time With IOCHRDY Flow Control
0078
69-79
Reserved (for future command overlap and queuing)
0000
80 Major
version
number
0000h or FFFFh = device does not report version
15-4 Reserved for ATA-6~14
5 1=supports ATA/ATAPI-5
4 1=supports ATA/ATAPI-4
3 1=supports ATA-3
2 1=supports ATA-2
1 1=supports ATA-1
0 Reserved
003E
81 Minor
version
number
0000h or FFFFh = device does not report version
0000
82 Command
set
supported.
0000h or FFFFh = command set notification not supported
15 Reserved
14 1=NOP command supported
13 1=READ BUFFER command supported
12 1=WRITE BUFFER command supported
11 1=WRITE VERIFY command supported
10 1=Host Protected Area feature set supported
9 1=DEVICE RESET command supported
8 1=SERVICE interrupt supported
7 1=release interrupt supported
6 1=look-ahead supported
5 1=write cache supported
4 1=supports PACKET Command feature set
3 1=supports power management feature set
2 1=supports removable feature set
1 1=supports security feature set
0 1=supports SMART feature set
7C6B
11
ATA-3 defines this field as “Vendor specific (obsolete)” To maintain compatibility between ATA-2, the drive supports this field as
specified in ATA-2. This field may be used for other purposes in future models.