Ultra electronic MAGICARD Sicura Laminator - Manual (Page 2)

Quick Start Guide Ultra Electronics Card Systems
Page 2 MAGICARD Sicura Laminator
Setting up your Sicura Laminator
takes just two easy steps:
1.
Unpack and install the laminator
A Preparing a Location for the Laminator
B Removing the Laminator from the Box
C Check the Package Contents
D Install the Lamination Film
E Connect the Laminator to a Power Supply
F Set the Optimum operating temperature and test the
Laminator Operation
G Interfacing to a Rio/Tango printer
Important Note for Setting Up your Rio/Tango Printer Driver to work
with the Sicura Laminator
H Interfacing to a Turbo series printer
2.
Stand-alone Mode
I Operation of the Hopper
J Adjusting the Hopper
K Error Indicators
3.
Verify correct operation
L Important Cleaning Procedures
M In Case of Difficulty
Note: The Ultra WEB site at http://www.ultramagicard.com contains comprehensive technical support
information including the latest downloadable software, WINDOWS Drivers, Technical Bulletins etc
Conventions
Throughout this guide, the following conventions are used to identify important
information.
WARNING - Warning messages indicate where personal injury could result from not
following the correct procedures.
CAUTION - Caution messages indicate where damage to equipment could result
from not following the correct procedures.
NOTE - Notes convey important information that is identified within the text.