Ultra electronic MAGICARD Sicura Laminator - Manual (Page 20)

Quick Start Guide Ultra Electronics Card Systems
Page 20 MAGICARD Sicura Laminator
Correction operation depends on clean rollers to transport cards, an undamaged
laminating roller, and a dust-free environment.
It is recommended that the laminator be cleaned after every roll of lamination film
(250 cards).
PREPARATION
Set the temperature controller to 20
°C, then switch off.
Allow to cool down for 15 minutes.
Remove cards and both film cores.
CLEAN DUST FROM FILM BOSSES
Using a slightly damp cloth, wipe any plastic dust from the two film core bosses, the
retaining plate, and any visible dusty surfaces.
CLEAN THE ROLLERS
Switch the laminator on.
Using a slightly damp cloth, wipe the exposed surfaces of the two pinch rollers and
the laminating roller. Operate the open/close lever to turn the rollers.
Switch off and allow to dry.
RE-LOAD
Re-load the laminator with a fresh roll of film and take-up core. It is not recommended
that take-up cores be re-used.
New cores are supplied with each roll of film.
Switch on and set the temperature controller to the desired laminating temperature.
When warmed up, laminate two or three plain cards to get rid of any residual dust and
to check the film alignment on the card.
Important Cleaning Procedures Important Cleaning Procedures
L