Ultra electronic MAGICARD Sicura Laminator - Manual (Page 21)

Ultra Electronics Card Systems Quick Start Guide
MAGICARD Sicura Laminator Page 21
Check the Installation:
• Repeat the installation steps in this guide.
• Check that the laminator mains voltage is correct.
• Check that the laminating film is the right way round and passes through the
optical sensor.
• Check that the unit has warmed up (3 minutes).
• Check that the rollers are clean.
• Check the status of the Error LEDs (section K).
For further assistance:
• There are a number of useful Technical Bulletins on the MAGICARD WEB page at
http://www.ultramagicard.com . If you do not have WEB access, copies can be
requested from Customer Service.
• Call your local Dealer, giving the Model Number and Serial Number, a description
of the nature of the problem, and the flashing error codes if pressent.
• Call the Ultra Magicard Customer Service Hotline number - +44(0)1305 762115 or
+44(0)11305 762121.
• Email us at:
[email protected] .
M
In Case of Difficulty