Vanguard Managed Solutions Vanguard 342 - Manual (Page 102)

B-2 Software License and Regulatory Information
FCC Part 68 and Telephone Company Procedures and Requirements for DSU, T1, and ISDN Interfaces
FCC Part 68 and Telephone Company Procedures and
Requirements for DSU, T1, and ISDN Interfaces
Introduction The equipment referenced in this section is compliant with FCC Part 68 rules.
Before You Begin Before connecting a Vanguard 340 to a network, you should:
• Provide the local telephone company with the equipment’s registration
number.
• Order the proper connections.
How to Order
Connections To order the proper connections, provide the telephone company with:
• Interface type
• Required USOC jack connector number
• Service code
• Facility interface codes
Troubleshooting
Your Connection If any of your equipment is not operating correctly, immediately remove it from the
telephone line before damaging the network. If the telephone company is aware of
the problem, they may temporarily disconnect your service. Whenever possible, the
telephone company notifies you in advance of the disconnection.
If advance notice is not feasible, you are notified as soon as possible. Once notified,
you can correct the problem. If necessary, it is your right to file a complaint with the
FCC.
Interface Type USOC Jack
Connector
Service
Code
Facility Interface
Code
56-kbps digital interface RJ48S 6.0F 04DU5-56
ISDN U Interface RJ49C 6.0Y 02lS5
ISDN S/T Interface -------- 6.0F 02lS5
Fractional T1 Interface RJ48C 6.0F 04DU9-BN
04DU9-2SN
V.90 Modem Interface RJ11C ---------- ----------