Vanguard Managed Solutions Vanguard 342 - Manual (Page 90)

4-2 Powering Up and Loading Software
Powering Up Your Vanguard 342
Powering Up Your Vanguard 342
Introduction This section describes the sequence of events when you power up and power down
the Vanguard 342.
Powering On the
Vanguard 342 The Vanguard 342 does not have a power switch on the unit. Use these steps to
power on the device:
1) Plug the DC output cable of the power supply into the power socket on the
Vanguard 342 back panel.
2) Connect the power cord to the power supply outlet.
Resetting the 342 The RESET button resets the node. Pressing the RESET button is the equivalent of a
power-up operation which clears all existing calls and brings down all links.
For the location of the RESET button, refer to the “Enclosure” section in Chapter 2.