Vanguard Managed Solutions Vanguard 342 - Manual (Page 69)

Installation and Replacement 3-15
Cabling the Vanguard 342
Port Numbering for
Physical Ports 1
and 2 Daughtercards installed in ports 1 and 2 must be configured correctly. For example,
if you have installed a Dual E&M daughtercard in port 1 you must configure the port
as an E&M port. In addition, use this port numbering scheme when configuring the
Vanguard 342:
Note
For more daughtercard configuration information, refer to Chapter Five of the
Daughtercard Installation Guide (Part Number T0020).
Daughtercard
Cable Information Cables for optional daughtercards are shipped with the daughtercards. If your
Vanguard 342 is shipped with pre-installed daughtercards you will receive the
cables. For daughtercard installation and more cable information, please refer to the
Vanguard Daughtercard Installation Guide (Part Number T0020).
5 RJ45 10/100BaseT 10/100BaseT Adapter
cable
or standard UTP cable
(RJ45-to-RJ45)
10/100Mbps Auto
Sensing Interface # 1
8RJ45 10/100BaseT 10/100BaseT Adapter
cable
or standard UTP cable
(RJ45-to-RJ45)
10/100Mbps Auto
Sensing Interface # 2
Port Connector Interface Cable Required
(Application Specific)
Speed DCE/DTE
(continued)
If the daughtercard is
installed in...
...and it has one port
connector, configure
port
...or it has two port
connectors,
configure port
Port 1 1 1 or 6
Port 2 2 2 or 7