Pre l iminar y – Vidikron VP-5000 User Manual
Page 17
Vidikron PlasmaView Owner’s Operating Manual
7
PRE
L
IMINAR
Y
1.
POWER INPUT (100 to 240 VAC)
Connect the PlasmaView to power here, using the included power cord.
2.
EXTERNAL SPEAKER OUTPUTS
Connect optional, external speakers here. Maintain the correct polarity. Connect the
(positive) and
(negative) speaker wires to the EXT SPEAKER terminals on both the
LEFT and RIGHT channels. Please refer to the owner’s manual for your speakers.
3.
VIDEO1, 2 (RCA, S-Video)
Standard, Composite video and S-Video inputs for connecting a DVD player, satellite
receiver, camcorder, laser disc player or Super VHS (S-VHS) VCR.
4.
AUDIO1, AUDIO2, AUDIO3
Stereo, RCA-type audio inputs. You can associate each audio input with any video input
-- that is, specify which audio input becomes active when a given video source is
selected. For more information, refer to Audio Setup on page 32.
5.
DVD/HD1
DVD/HD2
Standard-definition (480i/576i) or high-definition (720p/1080i), YPrPb component
inputs for connecting a DVD player or high-definition TV source.
6.
PC/RGB (15-pin D-Sub)
Connect an analog RGB signal from a computer or DTV decoder here.
7.
DVD/HD3, DVD/HD4 (HDMI)
HDCP-compliant digital video input for connecting a DVD player, personal computer or
HD tuner with a DVI or HDMI output.
8.
EXTERNAL CONTROL (9-pin, male D-Sub)
A male, 9-pin D-sub connector for interfacing with a PC or home theater
automation/control system.
9.
REMOTE IN (3.5-mm mini phone jack, tip/ring/sleeve)
Wired input from an external remote control or infrared (IR) receiver.
10. REMOTE OUT (3.5-mm mini phone jack, tip/ring/sleeve)
Wired output to the REMOTE IN jack of another device; allows you to control both the
PlasmaView and the other device using the same wired remote control.
For best results, do not run your DVD player in progressive mode.
Tip