Vidikron VP-5000 - Manual (Page 48)

Operation
38 Vidikron PlasmaView Owner’s Operating Manual
PRE
L
IMINAR
Y
Sub. Picture: Select Sub. Picture from the Function menu to change certain behaviors of the
Picture-in-Picture, Zoom or Image Freeze features.
• Sub. P Detect (Picture-in-Picture mode): When you set this to AUTO, the PlasmaView
removes the black sub-picture frame from the screen approximately three seconds after
the sub-picture input signal is lost in Picture-in-Picture mode. When you set this to OFF,
the black frame remains on-screen regardless of the presence or absence of an input
signal.
• Display: This item controls the manner in which the sub-window appears when you
invoke Picture-in-Picture, Zoom or Image Freeze. FADE causes it to fade in gradually;
NORMAL causes it to appear right away, with no transition.
• Sub. P Rate: This item controls the opacity of the sub-window when using Zoom, Image
Freeze or Picture-in-Picture. Lower settings allow the main image to show through the
sub-window (100% = no show-through).
Zoom Nav: Select Zoom Nav from the Function menu to change the position of the small
navigation window that appears when you invoke the Zoom feature. Select BTM LEFT,
BTM RIGHT, TOP LEFT, TOP RIGHT or S BY S. Figure 4-8 shows the effect of each of these
settings.
Figure 4-7. Zoom Navigation Modes
To hide the navigation window, select OFF. When you do, an icon appears in the center of the
screen to indicate that you are in Zoom mode.
1. The Picture-in-Picture, Zoom and Image Freeze functions are available only via
serial commands or a third-party remote control unit that has been
programmed to access these functions. For more information, refer to Section 6,
Serial Communications, or contact Vidikron Technical Support .
2. The Zoom function is available only when the Aspect Ratio is set to 16:9 or 4:3.
Note
Bottom
Right
Top
Right
Bottom
Left
Top
Left
S BY S