Vidikron VP-5000 - Manual (Page 51)

Operation
Vidikron PlasmaView Owner’s Operating Manual 41
PRE
L
IMINAR
Y
Pwr. On Select: Select Pwr. On Select from the Function menu to specify which input signal
is displayed when you turn on the PlasmaView. You can also specify an initial audio volume
level.
You can select a specific input or volume level (0 to 42). Or, select LAST to have the
PlasmaView set the input and volume to what they were the last time it was turned off.
Signal Info Select Signal Info from the Main menu to check the frequencies and polarities of the current
input signal. (If RGB/PC is the current input, “MODE” is replaced by “MEMORY.”)
Press EXIT to return to the Main menu.
INPUT SELECT : RGB
VOLUME : 22
PWR. ON SELECT
SEL. ADJ. RETURN EXIT
H. FREQ : 48.4KHz
V. FREQ : 60.0Hz
H. POLARITY : NEG.
V. POLARITY : POS.
MODE : 480i
RESOLUTION : --
SIGNAL INFO
SEL. OK SEL. OK RETURN EXIT