Varec 4532 - Manual (Page 20)

Installation Average Temperature/Water Bottom Sensor and Converter
10 Installation and Operations Manual
4.2 Unpacking
When unpacking, be careful not to bend, fold or twist the flexible tube. Please refer to
the recommended procedure below.
4.3 Flexible tube
When attaching and bending the flexible tube, the radius of curvature must be at least
300 mm (11.8") at any bend portion.
Figure 4-2: Flexible tube
Note! If a flexible tube is bent with a radius of curvature less than 300 mm (11.8"), the flex-
ible tube or the measuring element may be seriously damaged or broken.
Recommended procedure Incorrect procedure
Min.1m (39.37")
Flexible tube