3 device set up: 6000 series servo tank gauge, 1 preparation of 6000 series servo tank gauge, Device set up: 6000 series servo tank gauge – Varec 4532 User Manual
Page 38: Preparation of 6000 series servo tank gauge
Operating
Average Temperature/Water Bottom Sensor and Converter
28
Installation and Operations Manual
7.2.2
The 4532 ATC specific parameter set up on the 4590 TSM
Configuration of 4532 ATC parameters on the display of the 4590 TSM is dependent on
the installed software and hardware version of the 4590 TSM. Please refer to the
operating manual for the 4590 TSM to determine accessible parameters.
All required initial setup and configuration can be performed by the ToF field service
tool. Detailed information will be described in the following operation related chapters.
7.3
Device set up: 6000 Series Servo Tank Gauge
The 6000 Series Servo Tank Gauge is also specifically designed to recognize the 4532
ATC. Connect local HART cabling between the 4532 ATC and the 6000 Series Servo Tank
Gauge on terminals 24 and 25.
7.3.1
Preparation of 6000 Series Servo Tank Gauge
The 6000 Series Servo Tank Gauge must be pre-configured to accept the 4532 ATC
connection via the multi drop HART loop.
GVH362: NMT connection
"Average Temp." must be selected in order to configure the 4532 ATC.
Caution!
To change this parameter, an access code is required. Please refer to the 6000
Series Servo Tank Gauge operation manual for further information.
7.3.2
4532 ATC configuration on 6000 Series Servo Tank Gauge
Most required 4532 ATC parameters can be configured on G4 "Temperature" matrix as
it is on the display of the 6000 Series Servo Tank Gauge.
Typical 4532 ATC parameters (equivalent to the 4535 ATC) are displayed on the matrix
of the 6000 Series Servo Tank Gauge.
7.3.2.1
G0 Static matrix
GVH010: Liquid Temp
Calculated average liquid temperature value, determined by the 4532 ATC
GVH013: Gas Temperature
Calculated average gas phase temperature value, determined by the 4532 ATC
GVH440: Liquid Temp
The same value indicated on GVH010 Liquid Temp
GVH441: Gas Temperature
The same value indicated on GVH013 Gas Temperature
GVH442: Measured Level
Liquid level value established in the 6000 Series Servo Tank Gauge. The 4532 ATC must
have liquid level data in order to calculate both liquid and gas phase average
temperature.