Vidikron Vision 50 - Manual (Page 26)

Installation
14 Vidikron Vision 50 Series Owner’s Operating Manual
PRE
L
IMINAR
Y
3.2
Quick Setup Table 3-1 gives a quick overview of the Vision 50 installation process. The sections following
this one provide detailed instructions.
Installation should be performed by a qualified custom video installation
specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1 Choose a location for the projector 15
2
If installing a Vision 50/CineWide or Vision 50/CineWide
with AutoScope: Install fixed CineWide base plate or
AutoScope lens motor (optional) 19
3 Mount the projector 24
4 Connect signal sources to the Vision 50 25
5 Connect external controller to RS-232 port (optional) 29
6
Connect 12-volt trigger output to AutoScope lens motor or
other equipment (optional) 30
7 Apply power to the projector 31
8 Change the OSD Language (optional) 32
9
For rear-screen and/or ceiling-mount installations, select the
proper picture orientation 32
10
Primary lens adjustments: projected image size (zoom),
position (shift) and focus 17, 32
11 Install CineWide anamorphic lens (optional) 33
12
CineWide lens adjustments: position, pitch (angle), geometry
and focus 38
13
Projector calibration: adjust the following for each input,
starting with Component 1; save settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Input position 51 through 57
Note