Vidikron Vision 50 - Manual (Page 44)

Installation
32 Vidikron Vision 50 Series Owner’s Operating Manual
PRE
L
IMINAR
Y
3.8
Changing the OSD
Language The Vision 50 OSD language is initially set to English, but can also display the menus in
French, Spanish, Italian or German. To change the OSD language:
1. Press MENU.
2. Select Installation from the Main Menu and press ENTER.
3. Select Language from the Installation Menu and press ENTER.
4. Press or to highlight the desired language. (The change takes effect immediately.)
3.9
Adjusting the Picture
Orientation By default, the Vision 50 is configured for a “floor/front” installation, in which the projector is
installed upright and in front of the screen. If it is installed behind the screen and/or mounted
on a ceiling, you must change the picture orientation. To do this:
1. Press MENU on the remote control.
2. Select Installation from the Main Menu and press ENTER.
3. Select Picture Orientation from the Installation Menu and press ENTER.
4. Choose Floor Rear, Ceiling Front or Ceiling Rear to match the installation method.
3.10
Primary Lens Adjustments The Vision 50 gives you a great deal of control over the picture
size, position and focus. To access the motorized lens controls,
use the FOCUS, ZOOM and LENS SHIFT buttons on the
remote control.
Focus To focus the projected image, press the FOCUS button, then use the left- and right-arrow
buttons to adjust the focus.
Zoom To make the picture smaller (zoom out), press the ZOOM button, then use the left-arrow
(
) button.
To enlarge the picture (zoom in), press the ZOOM button, then use the right-arrow ( )
button.
Vertical Lens Shift To shift the projected image vertically, press the LENS SHIFT button, then use the up and/or
down-arrow (
, ) buttons.
➤
➤
➤