Configure lens motor trigger, Adjusting the horizontal (x) lens position, Pre l iminar y – Vidikron Vision 50 User Manual
Page 50
38
Vidikron Vision 50 Series Owner’s Operating Manual
PRE
L
IMINAR
Y
Configure Lens Motor Trigger: CineWide with AutoScope maintains constant image height
independent of the aspect ratio, while using the full display resolution of the projector. It
accomplishes this by moving the anamorphic lens in front of the primary lens when
widescreen material is being viewed. When the viewer transitions back to 16:9 or 4:3 source
material, the anamorphic lens moves out of the light path.
To configure the lens motor trigger on the Vision 50 for proper AutoScope operation:
1.
Press MENU on the remote control.
2.
Select Service from the Main menu and press ENTER.
3.
Use the number buttons on the remote to enter the Service menu passcode when
prompted and press ENTER again. Then, press MENU on the remote control.
4.
Select Screen Trigger Mode from the Service menu.
5.
Set the Screen Trigger Mode to “Trigger.” This enables the lens motor to move the
anamorphic lens into position (in front of the primary lens) when the Cinema or Cinema
Fill aspect ratio is selected.
6.
Select the Cinema or Cinema Fill aspect ratio to move the anamorphic lens into position,
if it isn’t already. To do this, press CINEMA or C-FILL on the Vision 50 remote control
(Figure 2-4).
Adjusting the Horizontal (X) Lens Position:
1.
Project a white field on the screen.
2.
Loosen the Yaw/X-Adjustment Levers underneath the lens.
3.
Slowly move the anamorphic lens into place so that there are no shadows on either side
of the screen:
4.
When the horizontal position is properly set, tighten the Yaw/X-Adjustment Levers to
secure the lens in place.
Too Far Right
Too Far Left
Correct position