3 installation, 1 remote control, Notes on batteries – Vidikron VP-4200a User Manual
Page 23: Notes on remote control operation, Figure 3-1 . available range of the remote control, Installation, Remote control, 1. available range of the remote control, Pre l iminar y
Vidikron PlasmaView Owner’s Operating Manual
13
PRE
L
IMINAR
Y
3.1
Remote Control
To install batteries in the remote control:
1.
Remove the battery cover from the
back of the remote control.
2.
Insert the batteries included with the
remote control. Ensure that the
polarities correctly match the
and
markings inside the battery
compartment.
3.
Replace the battery cover.
Notes on Batteries
• When installing batteries, make sure that the battery polarities are correct.
• Do not mix an old battery with a new one or different types of batteries.
• If you will not use the remote control for a long time, remove the batteries to avoid
damage from battery leakage.
Notes on Remote Control
Operation
The remote control can be used to control the PlasmaView within the ranges shown in Figure
3-1.
Figure 3-1. Available Range of the Remote Control
3
Installation
While pressing down lightly, slide
in the direction of the arrow.
Two AA (R6)
batteries
Approx.
23 ft (7m)
S / V
COMP
DVI VIDEO
DVI-D
RGB-HD
POWER
ASPECT
RATIO
RGB
SETUP
INFO
INPUT SELECTION
PIP FUNCTION
MENU
MAGNIFY
SET
MUTE
VOLUME
P-OFF
P-ON CLEAR
SPLIT SUB INPUT
SWAP
PIP SHIFT
1
2
3
4
5
-
+