Audio connections, Attaching the ferrite cores to the audio cables, Audio inputs – Vidikron VP-4200a User Manual
Page 33: Figure 3-10 . connecting audio inputs, Iminar, 10. connecting audio inputs, Pre l iminar y
Vidikron PlasmaView Owner’s Operating Manual
23
PRE
L
IMINAR
Y
Audio Connections
Attaching the Ferrite Cores to the Audio Cables: Three (3), small ferrite cores are provided
with the PlasmaView. Before connecting your audio equipment, attach a ferrite core to each
audio cable as shown in Figure 3-9. Doing so will reduce radio frequency interference (RFI)
emissions to a level that conforms to FCC regulations.
Wind the audio cable around the ferrite core once, then fasten the catch. If you are using all
five audio inputs and/or the audio output (see Figure 3-11), obtain and install additional
ferrite cores as needed.
Figure 3-9. Attaching the Small Ferrite Cores to Audio Cables
Audio Inputs: The PlasmaView has five (5), stereo audio inputs; each one corresponds to a
video input.
Connect the audio outputs from your source components to these inputs using a cable with
a stereo miniplug at the PlasmaView end and the appropriate connector(s) (stereo miniplug
or dual RCA plugs) at the other end; see Figure 3-10.
Figure 3-10. Connecting Audio Inputs
Small Ferrite Core
Audio Cable (not supplied)
AUDIO
INPUT1
AUDIO
INPUT2
AUDIO
OUTPUT
INPUT 1 / INPUT 2
INPUT 5 / INPUT 4 / INPUT 3
COMPONENT