Vidikron VP-4200a - Manual (Page 62)

Maintenance and Troubleshooting
52 Vidikron PlasmaView Owner’s Operating Manual
PRE
L
IMINAR
Y
Picture is okay, but there is no
sound. • Audio output is muted.
• Volume setting is too low.
• Source component is
connected incorrectly or
not at all.
• Press the MUTE button on
the remote control.
• Turn up the volume.
• Check audio connections to
source component.
Image is too bright and/or
lacks definition in the bright
areas of the image. • Contrast is set too high. • Lower the contrast setting.
Image appears “washed out”
and/or dark areas appear too
bright. • Brightness is set too high. • Lower the brightness
setting.
Colors in the image are
swapped; for example, reds
appear blue or vice versa. • Incorrect color space
setting.
• The Pr, Y or Pb outputs from
the source to Input 4 on the
PlasmaView are incorrect.
• Select the correct color
space (refer to Color Space
on page 40).
• Ensure that the YPbPr
(component) source output
connections to Input 4 are
correct (see Figure 3-7).
RGB-HD images appear
“noisy.” • Frequency and Phase
settings need adjustment. • Manually adjust Frequency
and Phase settings, or
perform an Auto Setup
(refer to Screen on
page 38).
One of the following error
messages appears on-screen:
•
CAUTION
OUT OF RANGE
• CAUTION
UNSUPPORTED SIGNAL
• SIGNAL NG
• The resolution and
frequency of the video card
in the computer are not
compatible with the
PlasmaView. • Select a compatible
resolution and vertical
frequency (refer to
Computer/Video Signal
Compatibility on page 69).
The image is too large or too
small. • Image size needs adjusting. • Adjust the image size (refer
to Screen on page 38).
One of the following error
messages appears on-screen:
•
WARNING
THERMAL ALERT
SHUT DOWN (**)
• WARNING
FAN FAILURE
SHUT DOWN (**)
(“(**)” represents a two-digit
error code.)
• Ambient temperature is too
high.
• Cooling fan has
malfunctioned.
• Turn off main power.
Remove any objects
blocking the cooling vents
on the PlasmaView and/or
clean the vents.
• Immediately turn off
power, remove the power
plug from its outlet, and
consult your Vidikron
dealer.
Table 5-1. Troubleshooting Chart (continued)
Symptom Possible Cause(s) Solution