Vidikron VP-4200a - Manual (Page 51)

Operation
Vidikron PlasmaView Owner’s Operating Manual 41
PRE
L
IMINAR
Y
Sub Volume (Installer Adjust mode): Select Sub Volume from the Set-Up menu to adjust
the audio input level for the current source. Do this for all sources, as needed to prevent
sudden, drastic changes in sound volume when switching inputs.
For example, if a DVD player is connected to Input 4, a computer is connected to Input 1 and
the audio output of the DVD player is fixed at a much higher level than that of the computer,
reduce the Sub Volume for Input 4.
The Sub Volume control affects the current input only; the front-panel and remote volume
controls are “master” controls; see Figure 4-7.
Figure 4-7. Audio System Functional Block Diagram
Option Language: Refer to Changing the OSD Language on page 27.
Energy Mode: Select Energy Mode from the Option menu to reduce power consumption
and panel deterioration by limiting brightness of the screen. You can choose to limit
brightness according to the input signal or in response to the ambient light level.
• Select LEVEL 1 to limit brightness in accordance with the input signal. Power consumption
is less than that used in AVERAGE mode.
• Select LEVEL 2 to limit brightness in accordance with the input signal. Power consumption
is less than that used in LEVEL1 mode.
• Select LEVEL 3 to set the brightness at fixed level, regardless of input signal level (useful
for preventing screen aging due to image burn).
• Select AUTO to have the PlasmaView adjust the brightness automatically in response to
ambient lighting conditions, to optimize picture quality.
• To disable the Energy Mode feature, select MUTE.
Time/Date: Select Time/Date from the Option menu to set the PlasmaView’s internal clock
(time of day and day of the week) and turn the screen maintenance feature on or off.
• Present Time: To set the internal clock, highlight Present Time and press SET. Then, use
the right- or left-arrow buttons ( , ) to set the time. Press SET again when you are
finished.
• Program Timer: Set Program Timer to PROGRAM to enable the PlasmaView’s screen
maintenance feature, which lets you replace the normal source signal with a white field,
an inverse image or an “orbiting” image. This occurs according to the schedule you
establish using the Screen Maint. menu in Installer Adjust mode (refer to Screen Maint. on
page 43).
Select Return to exit the Time/Date menu.
1 AUDIO INPUT
(INPUT1)
2 AUDIO INPUT
(INPUT2)
3 AUDIO INPUT
(INPUT3)
4 AUDIO INPUT
(INPUT4)
5 AUDIO INPUT
(INPUT5)
INPUT1
SUB VOLUME
INPUT2
SUB VOLUME
INPUT3
SUB VOLUME
INPUT4
SUB VOLUME
INPUT5
SUB VOLUME
INPUT
SELECTOR POWER
AMPLIFIER
VOLUME
INPUT 3 PLASMAVIEW
SCREEN SET-UP OPTION PICTURE
SET SET EXIT MENU
: ENGLISH
: AUTO
: OFF
: OFF
LANGUAGE
ENERGY MODE
TIME / DATE
SCREEN MAINT.
AUTO SETUP MODE
AUTO FUNCTION