Vidikron VP-4200a - Manual (Page 52)

Operation
42 Vidikron PlasmaView Owner’s Operating Manual
PRE
L
IMINAR
Y
Screen Maint. (Pixel Protect): Select Screen Maint. (Pixel Protect) from the Option menu
to configure the image burn-in prevention settings on the PlasmaView.
• Orbiter: Select Orbiter from the Screen Maint. (Pixel Protect) menu to set the picture
shift.
• OFF: Orbiter mode does not function.
• TYPE 1: The image size is reduced so the entire image remains in the display area while
orbiting.
• TYPE 2: The image is enlarged so there are no black bands in the display area while
orbiting.
• TYPE 3: The image size is unchanged.
• Soften: Select Soften from the PDP Mgmt. menu to reduce edges (color transitions) and
soften the image.
• OFF: Turns the SOFTEN function off.
• 1, 2, 3, 4: Activates the SOFTEN setting. Higher numbers create a “softer” image.
Auto Setup Mode: The PlasmaView can automatically adjust the position, frequency and
phase of incoming computer signals for optimum picture quality whenever the display is
turned on, or when a different input or input signal type is selected. To enable this feature,
select Auto Setup Mode from the Option menu and set it to ON.
1. When TYPE 1 or TYPE 2 is selected, the image movement is continuous;
TYPE 3 causes the image to move one pixel at a time.
2. The Orbiter does not function while the MAGNIFY feature is in use.
Under some conditions – such as when the input signal consists of mostly
dark colors – Auto Setup may not produce the desired results. If this
occurs, set Auto Setup Mode to OFF and manually adjust the image
position, frequency and phase; refer to Screen on page 38.
Note
Note