Whirlpool ADVANTECH CL-8 - Manual (Page 45)

ADVANTECH ™ Management Software HotSync
36
Downloading Machine Setup Data to the Palm ™ Handheld via a HotSync ®
Once you have setup your passwords, locations, and
templates you can download the information from the
PC to the PDA via the HotSync
® process. The PDA will
be in Open-Access Mode until the first HotSync ®
operation is performed. In Open-Access mode your
machines are vulnerable to any PDA with the Handheld
Software loaded on them, however, only a limited
number of utilities are available in this mode: Get/Set
Time, Get Setup, Start/End Cycles, Audit Count,
Service Mode, and Run Diagnostics. It is recommended
that you sync your PDAs with the Management
Software and initialize your machines as soon as
possible after installation. After the first HotSync
®
operation has been performed the PDAs will then be in
Synced Mode, where all features will become
available.
Before performing a HotSync
® operation, make sure the
Management Software has been launched on the PC
and that the Palm
™ handheld is in its cradle. Refer to
page 15 of this manual for instructions on installing the
Handheld Software.
1. Click on PDA Sync.
2. Click on Execute
PDA Data Transfer.
3. Press the HotSync ® button on the HotSync ® cradle
or cable.
4. When the HotSync ® operation is complete, click OK on
the PC, then click on Exit. The Palm ™ handheld screen
will look like this:
5. On the Palm ™ handheld, use the stylus to tap the Home
icon, located to the left of the Graffiti ® writing area. This
will display the main menu screen on the PDA.