Wells WFGA-60FS - Manual (Page 16)

14
MAINTENANCE INSTRUCTIONS
A. CRADLE LIFT ASSEMBLY LUBRICATION
PINCH HAZARD
DISCONNECT THE FRYER FROM ELECTRICAL POWER BEFORE
LUBRICATING THE CRADLE LIFT DRIVE SCREW.
Failure to disconnect power may allow the lift motor to
start unexpectedly, causing serious injury.
NOTE: Failure to keep the cradle lift screw properly lubricated will result in premature wear
of the brass lift nut Wear caused by lack of proper lubrication is NOT covered by warranty.
1. Disconnect the fryer from electrical power.
2. Open the rear access panel. Coat the exposed threads of the cradle lift screw with moly
(molybdenum disulfide) grease.
3. Close the access panel and restore electrical power.
4. Recommended frequency is “as required”, and, at a minimum, every six months.
Lubricate the cradle lift screw immediately if a grinding or rubbing noise is heard as the
basket is raising.
GREASE
THREADS
CRADLE LIFT
DRIVE
SCREW
ACCESS
PANEL
BRASS
NUT
CRADLE
LIFT
DRIVE
MOTOR