Wells WFGA-60FS - Manual (Page 17)

B. CRADLE ROLLER ASSEMBLIES
1. DAILY: Wash the cradle in the dishwasher or in the sink with
warm water and mild soap or detergent.
2. Thoroughly flush the bearings in the rollers with hot water
(under the faucet or with a spray nozzle).
Rinse the cradle thoroughly and dry.
3. Check the rollers to be sure they roll freely. Check bearing
nuts - keep them tight!
NOTE: Smooth operation of the rollers is essential to the
life of the fry kettle. If the rollers donot spin freely during
operation, they will soon wear grooves through the frypot wall.
IF ROLLERS ARE FROZEN OR OTHERWISE FOUND TO NOT SPIN FREELY AFTER
BEING THOROUGHLY CLEANED, REPLACE THEM IMMEDIATELY.
Wear to the FRYPOT caused by frozen rollers is NOT covered by waranty.
C. FILTER LEAF ASSEMBLY
SLIPPING & FALLING HAZARD / SPILLED OIL
DO NOT USE CRADLE IF THE ROLLERS DO NOT SPIN FREELY.
REPLACE ROLLERS IMMEDIATELY IF THEY ARE FROZEN.
Oil spills may occur.
Death or serious injury may result from falls caused by slipping in oil
15
FILTER RAIL “B”
LOWER
FILTER SCREEN
SEPARATOR
UPPER
FILTER SCREEN
FILTER RAIL “A” STRAIGHT PIN
“L”-SHAPED PIN
TOP VIEW SIDE VIEW