Wells WFGA-60FS - Manual (Page 7)

INSTALLATION INSTRUCTIONS
5
A. UNPACKING AND INSPECTION
1. Carefully remove the FRYER from the carton. Remove all blue protective plastic film,
packaging materials and accessories from the FRYER and the FILTER RESERVOIR before
connecting electrical power to the FRYER or otherwise performing any installation procedures.
NOTE: DO NOT discard the CARTON and other PACKAGING MATERIAL until you have
inspected the fryer for hidden damage and tested it for PROPER OPERATION.
Refer to SHIPPING DAMAGE CLAIM PROCEDURE on the inside front cover of this manual.
2. Read all instructions in this manual carefully before starting installation of this fryer. READ
AND UNDERSTAND ALL LABELS AND DIAGRAMS ATTACHED TO THE FRYER.
3. Carefully account for all components and accessories before discarding packing materials.
Store the accessories in a convenient place for later use:
COMPONENTS
1 ea. FILTER RESERVOIR
1 ea. FILTER LEAF with O-RING
4 ea. FILTER RESERVOIR SUCTION TUBE O-RING (on FILTER
RESERVOIR SUCTION TUBE)
1 ea. FRY BASKET, FULL SIZE
1 ea. LIFT CRADLE
1 ea. FRYPOT LID
ACCESSORIES
1 ea. LITERATURE PACKAGE
1 bx. FILTER POWDER
2 ea. HIGH TEMPERATURE BRUSHES
1 ea. STAINLESS STEEL SHOVEL
1 ea. CLEANOUT DOWEL (WOOD ROD)
1 ea. “T”-SHAPED SCRAPER w/ INSTRUCTIONS
B. SERVICE TECHNICIAN INSTALLATION NOTES
1. Installation and start up should be performed by an authorized installation company.
Installer must record fryer installation particulars on the CUSTOMER SERVICE DATA form on
page 27
of this manual.
2. Verify that this FRYER installation is in compliance with the specifications listed in this manual
and with local code requirements. THIS IS THE RESPONSIBILITY OF THE INSTALLER.
3. Certain codes require fryers to be restrained with a CABLE or other RESTRAINT DEVICE.
It is the RESPONSIBILITY OF THE INSTALLER to check with the AUTHORITY HAVING
JURISDICTION, in order to ascertain the applicability of this requirement to THIS SPECIFIC
FRYER INSTALLATION.