Wells WFGA-60FS - Manual (Page 18)

Clean the FILTER LEAF after each day’s filtration, or as needed to return oil promptly to the kettle.
See diagram, page 15.
IMPORTANT: Make sure that all oil is returned to the FRYPOT before proceeding.
1. Open the FRYER DOOR and slide the FILTER RESERVOIR forward to remove it. Remove
the FILTER LEAF from the Reservoir.
2. Disassemble the FILTER LEAF by separating the two side rails at the joint with the straight pin.
Clean all components in a sink with warm water and mild detergent, or in a dishwasher.
3. Assemble the SCREEN with the SEPARATOR installed between the two screens. Verify that
the O-RING is in place on the suction tube on the BOTTOM SCREEN. See diagram, page 15.
4. Slide the screens into SIDE RAIL “B” (L-shaped pin). Note that the handle will point away
from the suction tube on the BOTTOM SCREEN. Hook SIDE RAIL “A” over the pin on
SIDERAIL “B” and work the screens into SIDERAIL “A” until the straight pin on SIDE RAIL “A”
is held by the “bump” on SIDERAIL “B”.
5. Install the FILTER LEAF in the FILTER RESERVOIR with the suction tube firmly into the filter
reservoir drain hole.
6. Inspect the “O” RING on the FILTER SUCTION TUBE for damage. Replace the “O” ring if it
is cut, cracked or scuffed.
7. Install the filter reservoir into the fryer. Make sure the “O” ring closest to the end of the
SUCTION TUBE is firmly seated in the SUCTION LINE RECEPTACLE.
DANGER
BURN HAZARD / HOT OIL SPLATTER
DO NOT REMOVE FILTER RESERVOIR WHEN IT CONTAINS HOT OIL.
Contact with hot oil can cause death or serious injury.
PROTECTIVE CLOTHING AND GLOVES MUST BE WORN DURING
THE FILTERING PROCESS.
BURN HAZARD
DO NOT REMOVE EMPTY FILTER RESERVOIR IF IT IS HOT.
WEAR INSULATED GLOVES, OR ALLOW IT TIME TO COOL.
The hot oil will quickly heat the reservoir. Serious burns could result from
touching the hot filter reservoir with bare hands.
16