Wells WFGA-60FS - Manual (Page 9)

E. ELECTRICAL INSTALLATION
1. Fryer electrical diagram and troubleshooting schematic (item 22) are located on the inside of
the fryer door.
2. The fryer is equipped with a three-prong grounding plug (NEMA 15-5P) for your protection
against shock hazard. The fryer must be plugged directly into a properly grounded three-prong
receptacle (NEMA 15-5R).
3. The installation of this fryer must conform to local codes. In the absence of local codes, the
installation of this fryer must conform with the National Electrical Code (ANSI Z223.1).
In Canada, CSA C22.2 is applicable.
4. Because the fryer draws less than 8 amps, two fryers may be plugged into the same 15 amp
circuit if required.
3. This fryer is orificed at the factory for natural gas at a pressure of 3.5” of water column.
The installed orifice is suitable for use at -280 to 2999 feet (-85 to 914 meters) elevation.
It is the responsibility of the installer to install the factory recommended orifice and pressure
regulator kit suitable for the fuel type and elevation at the final installation site.
The red tag (p/n 301217) attached to the gas connection provides pressure settings and part
numbers for conversion kits applicable to various fuels and altitudes.
NOTE: Failure to install proper orifices can burn cooking oil and cause potential burner
and flue system failure.
Damaged caused by improper orifice installation is NOT covered by warranty.
CAUTION - ELECTRICAL SHOCK HAZARD
DO NOT CUT OR REMOVE THE GROUNDING PRONG FROM THE PLUG.
Ungrounded electrical equipment cause personal injury
and property damage.
7