2. hdd jumper setting – Western Digital 4CH TRIPLEX User Manual
Page 65
6. Assemble the rack containing the hard disk into DVR while holding up the handle.
7. Have the rack fixed in using the key of the rack. Otherwise, “HDD INSTALLATION
FAILURE” message will pop-up.
8. If the hard disk is not formatted and recognizable by DVR, an automatic formatting will
be done when the power of DVR is turned on. The notice “FORMATING” will appear on
the screen as shown below during formatting.
6-2. HDD Jumper Setting
DVR allows on one hard disk to be assembled into the REMOVEBLE HDD RACK and a new
hard disk’s JUMPER SETTING should be set to either SINGLE or MASTER. All hard disks
provide information needed for JUMPER SETTING on the hard disks’ exterior. Please beware
that DVR will not run properly without a proper JUMPER SETTING.
Refer to the following homepages of major hard disk manufacturers of additional information on
JUMPER SETTING.
WESTERN DIGITAL:
SEAGATE:
HITACHI:
MAXTER:
65