Delay->rev, Dist->delay, Appendix a: parameter lists – Yamaha DM2000 User Manual
Page 324
324
Appendix A: Parameter Lists
DM2000—Owner’s Manual
DELAY->REV
One input, two output delay and reverb effects in series.
DIST->DELAY
One input, two output distortion and delay effects in series.
Parameter
Range
Description
DELAY L
0.0–1000.0 ms
Left channel delay time
DELAY R
0.0–1000.0 ms
Right channel delay time
FB. DLY
0.0–1000.0 ms
Feedback delay time
FB. GAIN
–99 to +99%
Feedback gain (plus values for normal-phase feedback, minus val-
ues for reverse-phase feedback)
DELAY HI
0.1–1.0
Delay high-frequency feedback ratio
HPF
THRU, 21.2 Hz–8.00 kHz
High-pass filter cutoff frequency
LPF
50.0 Hz–16.0 kHz, THRU
Low-pass filter cutoff frequency
DLY.BAL
0–100%
Delay and delayed reverb balance (0% = all delayed reverb, 100% =
all delay)
REV TIME
0.3–99.0 s
Reverb time
INI. DLY
0.0–500.0 ms
Initial delay before reverb begins
REV HI
0.1–1.0
High-frequency reverb time ratio
DIFF.
0–10
Spread
DENSITY
0–100%
Reverb density
SYNC
OFF/ON
Tempo parameter sync on/off
NOTE L
1
1.
(Maximum value depends on the tempo setting)
Used in conjunction with TEMPO to determine left channel DELAY L
NOTE R
*1
Used in conjunction with TEMPO to determine right channel DELAY
R
NOTE FB
*1
Used in conjunction with TEMPO to determine FB. DLY
Parameter
Range
Description
DST TYPE
DST1, DST2, OVD1,
OVD2, CRUNCH
Distortion type (DST = distortion, OVD = overdrive)
DRIVE
0–100
Distortion drive
MASTER
0–100
Master volume
TONE
–10 to +10
Tone control
N. GATE
0–20
Noise reduction
DELAY
0.0–2725.0 ms
Delay time
FB. GAIN
–99 to +99%
Feedback gain (plus values for normal-phase feedback, minus val-
ues for reverse-phase feedback)
HI. RATIO
0.1–1.0
High-frequency feedback ratio
FREQ.
0.05–40.00 Hz
Modulation speed
DEPTH
0–100%
Modulation depth
DLY.BAL
0–100%
Distortion and delay balance (0% = all distortion, 100% = all
delayed distortion)
SYNC
OFF/ON
Tempo parameter sync on/off
DLY.NOTE
1
1.
(Maximum value depends on the tempo
setting)
Used in conjunction with TEMPO to determine DELAY
MOD.NOTE
2
2.
Used in conjunction with TEMPO to determine FREQ.