Zebra S4M - Manual (Page 54)

Operations
Position the Media Sensors 48
13290L-001 Rev. A S4M User Guide 10/21/05
Figure 22 • Adjusting the Reflective Sensor
To adjust the reflective sensor, complete these steps:
1. See Figure 22 . Press the printhead release latch.
2. Lift the printhead until it latches open.
3. Locate the reflective sensor positioning lever.
4. Move the reflective sensor positioning lever across the width of the media until the
reflective sensor aligns with the gap or notch.
5. Close the printhead assembly.
1 Printhead assembly
2 Reflective sensor
3 Adjustment lever
4 Printhead release latch
1
2
3
4