Setup mode, Enter setup mode, Leave setup mode – Zebra S4M User Manual

Page 58: Enter setup mode leave setup mode

Advertising
background image

Configuration
Setup Mode

52

13290L-001 Rev. A

S4M User Guide

10/21/05

Setup Mode

After you have installed the media and ribbon and the Power-On Self Test (POST) is complete,
the control panel displays

PRINTER READY

. You may now set printer parameters for your

application using the control panel LCD and the buttons directly below it. If it becomes
necessary to restore the initial printer defaults, see

FEED and PAUSE Self Test on page 103

.

Enter Setup Mode

To enter Setup mode, complete these steps:

1.

Press

MENU

.

2.

Use the left or right arrow to scroll through the parameters.

Leave Setup Mode

You can leave Setup mode at any time. As you leave Setup mode, you may choose to save or
discard changes that you made, or you may return to where you were in Setup mode.

To exit Setup mode, complete these steps:

1.

Press

MENU

.

The printer displays

SAVE CHANGES

and activates the

ENTER

button.

2.

Do you wish to save changes that were made since you entered Setup mode?

Important •

Certain printing conditions may require that you adjust some printing

parameters, such as print speed or darkness. These conditions include (but are not limited to):

• printing at high speeds

• peeling the media

• the use of extremely thin, small, synthetic, or coated labels

Because these and other factors affect print quality, run tests to determine the best
combination of printer settings and media for your application. A poor match may limit print
quality or print rate, or the printer may not function properly in the desired print mode.

If you wish to...

Then...

Save changes

a.

Press

ENTER

.

The printer saves changes and exits Setup mode.

Advertising