Zebra S4M - Manual (Page 76)

Configuration
Control Panel LCD Display 70
13290L-001 Rev. A S4M User Guide 10/21/05
LOAD DEFAULTS Load Factory Defaults
Sets all parameters back to factory defaults.
Important • Use care when using this command. All printer
parameters are reset to factory values with this command. If
possible, print a configuration label to have as a record of the
printer’s settings before loading defaults.
How to select this parameter:
1. Press ENTER .
The printer asks ARE YOU SURE?
2. To load factory defaults, press ENTER to select YES . To cancel, press
any other key.
INIT FLASH MEM Initialize Flash Memory
This parameter allows you to erase the printer’s Flash memory.
Important • The internal Flash memory is entirely erased with this
command.
To select this parameter:
1. Press ENTER to select YES .
The printer asks ARE YOU SURE?
2. To initialize Flash memory, press ENTER . To cancel, press any other
key.
RIBBON Set Ribbon Use
Note • This parameter appears only for printers that have the
Thermal Transfer option installed.
The printer can automatically detect if you are using ribbon. However, you
may use this parameter to tell the printer the method of printing that you
wish to use each time: direct thermal (no ribbon) or thermal transfer (using
ribbon).
Selections:
• AUTO (the printer detects if ribbon is present)
• NO (direct thermal mode, no ribbon)
• YES (thermal transfer mode, with ribbon)
Default Value: AUTO
To modify this parameter:
• Press the up or down arrow to scroll through the selections.
Table 11 • Printer Parameters, Level 3 (Page 6 of 9)
Parameter Explanation