Zebra S4M - Manual (Page 74)

Configuration
Control Panel LCD Display 68
13290L-001 Rev. A S4M User Guide 10/21/05
CONTROL CHAR
(ZPL mode only)
Set Control Character
The printer looks for this two-digit hexadecimal character to indicate the
start of a ZPL/ZPL II control instruction.
Note • Do not use the same hexadecimal value for the control,
command, and delimiter character. The printer must see different
characters to work properly.
Range: 00 to FF
Default Value: 7E (tilde—displayed as an arrow)
To modify this parameter:
• To increase the value, press the up arrow.
• To decrease the value, press the down arrow.
COMMAND CHAR
(ZPL mode only)
Set Command Character
The command prefix is a two-digit hexadecimal value used as a parameter
place marker in ZPL/ZPL II format instructions. The printer looks for this
two-digit hexadecimal character to indicate the start of a ZPL/ZPL II
format instruction. See the ZPL II Programming Guide Volume I for more
information.
Note • Do not use the same hexadecimal value for the control,
command, and delimiter character. The printer must see different
characters to work properly.
Range: 00 to FF
Default Value: 5E (caret)
To modify this parameter:
• To increase the value, press the up arrow.
• To decrease the value, press the down arrow.
DELIM. CHAR
(ZPL mode only)
Set Delimiter Character
The delimiter character is a two-digit hexadecimal value used as a
parameter place marker in ZPL/ZPL II format instructions. See the ZPL II
Programming Guide Volume I for more information.
Note • Do not use the same hexadecimal value for the control,
command, and delimiter character. The printer must see different
characters to work properly.
Range: 00 to FF
Default Value: 2C (comma)
To modify this parameter:
• To increase the value, press the up arrow.
• To decrease the value, press the down arrow.
Table 11 • Printer Parameters, Level 3 (Page 4 of 9)
Parameter Explanation