Zebra S4M User Manual
Page 86
Routine Maintenance
Cleaning Procedures
80
13290L-001 Rev. A
S4M User Guide
10/21/05
To clean the printhead and platen roller, complete these steps:
1.
Open the printhead assembly.
2.
Remove the media and ribbon.
3.
Using the swab from the Preventive Maintenance Kit (part number 47362) or a solution of
90% Isopropyl alcohol and 10% deionized water and a cotton swab, wipe along the brown
strip on the printhead assembly from end to end. Allow the solvent to evaporate.
4.
While manually rotating the platen roller, clean it thoroughly with the swab. Allow the
solvent to evaporate.
5.
Reload media and ribbon, and close the printhead assembly.
Caution • The printhead may be hot and could cause severe burns. Allow the printhead to
cool.
Note •
If performing this procedure does not improve print quality, try cleaning the
printhead with Save-A-Printhead cleaning film. This specially coated material removes
contamination buildup without damaging the printhead. Call your authorized Zebra
reseller for more information.