Zebra S4M - Manual (Page 23)

17 Printer Setup
Unpack and Inspect the Printer
10/21/05 S4M User Guide 13290L-001 Rev. A
Unpack and Inspect the Printer
When you receive the printer, immediately unpack and inspect it for shipping damage. Save all
packing materials.
Inspect the Printer
Inspect the printer for possible damage incurred during shipment:
• Check all exterior surfaces for damage.
• Raise the media door, and inspect the media compartment for damage to components.
Report Shipping Damage
If you discover shipping damage upon inspection:
• Immediately notify the shipping company and file a damage report.
• Keep all packaging material for shipping company inspection.
• Notify your authorized Zebra reseller.
Store the Printer
If you are not placing the printer into immediate operation, repackage it using the original
packing materials. You may store the printer under the following conditions:
• Temperature: –40°F to 140°F (–40°C to 60°C)
• Relative humidity: 5% to 85%, non-condensing
Shipping
If you must ship the printer:
• Remove any media or ribbon from the printer to avoid damaging the printer.
• Carefully pack the printer into the original container or a suitable alternate container to
avoid damage during transit. A shipping container can be purchased from Zebra if the
original packaging has been lost or destroyed.
Important • Zebra Technologies is not responsible for any damage incurred during the
shipment of the equipment and will not repair this damage under warranty