ZyXEL Communications Prestige 480 - Manual (Page 108)

Prestige 480 Dual BRI ISDN Router
IPX Configuration 6-4
6.2.2 Prestige on LAN without Server
Each IPX network must have a seed router. If you only have NetWare clients on your network, then you
must configure the Prestige as a seed router and set up unique network numbers for each frame type enabled
using the Ethernet Setup Menu.
6.3 IPX Spoofing
Your Prestige comes with several pre-defined call filters designed to prevent certain IPX packets from
triggering a call to a remote node.
The built-in call filters are defined as follows:
l Block periodical RIP (Routing Information Protocol) and SAP (Service Advertising Protocol) response
messages.
l Block NetWare serialization packets.
l Allow SAP and RIP inquiry packets.
6.4 IPX Ethernet Setup
From Menu 3 - Ethernet Setup, select option Novell IPX Setup to go to Menu 3.3 - Novell IPX Ethernet
Setup as shown in the next figure.
Menu 3.3 - Novell IPX Ethernet Setup
Seed Router= No
Frame Type 802.2= Yes
IPX Network #= N/A
Frame Type 802.3= No
IPX Network #= N/A
Frame Type Ethernet II= No
IPX Network #= N/A
Frame Type SNAP= No
IPX Network #= N/A
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.