ZyXEL Communications Prestige 480 - Manual (Page 159)

Prestige 480 Dual BRI ISDN Router
Filter Configuration 9-17
Figure 9-11 Filtering Remote Node traffic
9.4.3 Default Dial-in Filter
Use Menu 13.1 Default Dial-in Filter to specify the filter set(s) to apply to the incoming and outgoing
traffic between all dial-in users and your Prestige. Note that these filter set(s) only apply to the dial-in users
but not to the remote nodes. You can specify up to 4 filter sets separated by a comma, e.g., 1, 5, 9, 12, in
each filter field. The default is no filters.
Figure 9-12 Default Dial-in Filter
Menu 13.1 - Default Dial -in Filter
Input Filter Sets:
protocol filters=
device filters=
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
Factory
Default
Filter