ZyXEL Communications NetAtlas Workgroup - Manual (Page 181)

NetAtlas Workgroup Ethernet Switch Manager User’s Guide
181 Chapter 18 IP Configuration
Configure DSCP mappings in the DiffServ screen. Click IP Configuration > DiffServ to
display the screen as shown.
Figure 128 IP Configuration: DiffServ
The following table describes the labels in this screen.
18.8 Static Route
Static routes tell the switch how to forward IP traffic when you configure the TCP/IP
parameters manually.
1 In the Device Panel list, right-click on a device.
2 Click Configuration > IP Configuration > Static Route.
Table 99 DiffServ: DSCP Setting
LABEL DESCRIPTION
Active Select Active to enable DiffServ on the port.
DSCP to
802.1p
Mapping
0 … 63 This is the DSCP classification identification number.
To set the IEEE802.1p priority mapping, select the priority level from the drop-down list box.
Apply Click Apply to save the changes.