Zenith H20H52DT - Manual (Page 35)

Page 35
Installer Menus
Installer Menu Items 14-I through 27-I: Detailed Descriptions.
14-I. STRT CH IN SM
When set to 1, installs TV on/off event below the
start channel at TV turn on.
15-I. SLEEP TIMER
When set to 1, the SLEEP TIMER feature may be
used (but no message is displayed prior to turn-
off). When set to 0, the sleep timer is not
available.
16-I. EN. TIMER
Set to 1, timer function is available to user. Set to
0 to disable timer functions. (Clock must be set in
order to use Timers.)
17-I. ALARM
Gives you the option of making the alarm function
available to the user. Set to 1, alarm function is
available to user. Set to 0 to disable the Alarm
function.
Note: Clock must be set in order to set the Alarm.
18-I. RADIO
Set to 1, for TVs with a Radio. Set to 0 to disable
the Radio function, for TVs without a Radio.
19-I. NOT USED
20-I. FEATURE LEVEL
Default set to ZEN 1 for Zenith IR remote control
operation. Set O, P LBL for Zenith Private Label
IR remote control operation.
Warning: Do not set to “0” or remote will not
control TV.
21-I. V-CHIP
Set to 1 to activate V-Chip (Parental Control);
have it available to user to filter, control, or restrict
programming content. Set to 0 to turn V-Chip
feature off, not available to user; no programming
restrictions can be set.
22-I. MAX BLK HRS
Set to 0 to 99 for the maximum V-Chip (Parental
Control) block hours. Default is 12 blocking hours.
23-I. CAPTION LOCK
Set to 1 to restore previous caption On/Off state
after TV turns off. When set to 0, captions are
always off, when TV is initially turned on.
24-I. TEXT MODE
Determines whether TEXT 1, TEXT 2, TEXT 3, or
TEXT 4 decoding is enabled when TEXT is turned
on (either from the Setup Menu or directly with CC
on the remote). TIP: Set Text Mode to 1 only if text
is offered in your video System.
25-I. FUNCTION PRE.
Set to 0 to suppress CHANNEL PREVIEW from
the FUNCTION menu with some Pay-Per-View
systems.
26-I. 6 KEY SYS
Set to 1 for 6-key front control panels. Set to 0 for
10-key front control panels. Leave default set to 1.
27-I. HOSPITAL MODE
The default is 2 (which favors most hospitals).
With this setting two things are affected: Channel
Banks 1, 2, and 3 are accessible, while Bank 4 is
inactive.
Hosp. Mode=0 Not hospital mode. IR code
depends on Item 20-I.
“Inactive TV” features not available.
Hosp. Mode= 1 Zenith P.L. IR Code (Bed 1)
Hosp. Mode= 2 Zenith IR Code (Bed 2)
Characteristics
Channel up/down keys change channels only.
Channel down below the lowest channel (or channel up higher than the highest) and TV
turns off.
Channel down below the lowest channel (or up higher than the highest) and TV goes to
FM radio. Channel down below lowest FM station (or Channel up higher than the highest)
and TV channels return.
Channel down below the lowest channel (or up higher than the highest) and TV goes to
FM radio. Press channel down below lowest FM station (or Channel up higher than the
highest) and TV turns off.
Scan mode
0
1
2
3
Installer should leave item 20
FEATURE LEVEL set to 1 (default).