Zenith H20H52DT - Manual (Page 6)

Locate the Antenna/Cable jack on the
back of the HealthView TV.
Connect the antenna wire that runs from
the wall to this jack, according to one of
the diagrams shown to the right.
Remove the back of the optional remote
and put in two AA batteries.
Plug in the TV. The HealthView TV is
designed to operate on standard
current, 120-volt 60 Hertz AC. Do not
attempt to operate it on DC Power.
Go to page 11 to Auto Program the TV.
Antenna Hook Up
Connect an off-air antenna to the HealthView TV.
TV Back
Flat wire
(300 ohm)
Antenna
300/75 ohm
Adapter
TV Back
Antenna
RF Coaxial Wire
(75 ohm)
Back of
Remote
1
2
3
4
5
If you have a 75 ohm RF cable, then you
don’t need any adapters.
A 300 to 75 ohm adapter is not included
with the
HealthView TV. Zenith
The wire that comes from an off-air antenna or cable service provider. Each end looks
like a hex shaped nut with a wire sticking through the middle, and it screws onto the
threaded jack on the back of the TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They
are usually about an inch long with two screws on one end and a round opening with a
wire sticking out on the other end.
Mini Glossary
75 OHM RF
CABLE
300 TO 75
OHM
ADAPTER
Page 6
ANTENNA
CABLE
M.P.I.
TV Back Panel
(Expanded View)
PILLOW SPEAKER
TV SPEAKER
VIDEO IN SPEAKER OUT
AUDIO IN
ANTENNA
CABLE
M.P.I.
TV Back Panel
(Expanded View)
PILLOW SPEAKER
TV SPEAKER
VIDEO IN SPEAKER OUT
AUDIO IN