Zenith H20H52DT - Manual (Page 39)

LT2000 QuickSet Programmer
Page 39
The optional QuickSet II Clone Programmer (LT2000) allows custom setup and
programming information to be quickly copied from a master TV into multiple identical
television sets. Once learned from the master, setup data is retained in the LT2000 for future
use.
When using the LT2000, cloning operations will go easier if the TV set is connected to a
good quality signal and operating with a stable picture displayed. To operate the LT2000, use
the indicated keys on an HP602, LP702, or MBR3447 remote, or the front panel keys on the
TV receiver.
Use the Zenith LT2000 QuickSet II “Clone”
Programmer to copy the setup from a “master”
TV then quickly transfer the setup to duplicate
TVs must be the same model number as the
master TV.
Learn Master TV
Typical MPI Connections Teach Other TV
Typical MPI Connections
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION XX
THE TV IS VERSION XX
THE SW IS REVISION XX
CLONE CLOCK = XX:XX
TV CLOCK = XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.
TV Back
Antenna
RF Coaxial Wire
(75 ohm)
ANTENNA
CABLE
M.P.I.
TV Back Panel
(Expanded View)
PILLOW SPEAKER
TV SPEAKER
VIDEO IN SPEAKER OUT
AUDIO IN
Connect cable to
TV MPI Jack and
follow on-screen
instructions
Status
Indicator
Color
Blink pattern
battery OK
power on
no communications
power on
communications OK
battery low
green
slow
red
heart beat
Reset
MPI
QuickSet II Programmer
LT2000
ZENITH ELECTRONICS CORPORATION, GLENVIEW, ILLINOIS USA
Antenna
RF Coaxial Wire
(75 ohm)
TV Back
ANTENNA
CABLE
M.P.I.
TV Back Panel
(Expanded View)
PILLOW SPEAKER
TV SPEAKER
VIDEO IN SPEAKER OUT
AUDIO IN
Connect cable to
TV MPI Jack and
follow on-screen
instructions
Status
Indicator
Color
Blink pattern
battery OK
power on
no communications
power on
communications OK
battery low
green
slow
red
heart beat
Reset
MPI
QuickSet II Programmer
LT2000
ZENITH ELECTRONICS CORPORATION, GLENVIEW, ILLINOIS USA
Clone Clone