Yamaha DTX700 - Manual (Page 29)

KIT
DTX700 Reference Manual 29
Low Resonance (LowQ), Low Mid Resonance (Low-
MidQ), High Mid Resonance (HighMidQ), and High
Resonance (HighQ)
Use these parameters to specify widths for the low, low-mid,
high-mid, and high frequency bands, respectively. If you set a
large value, a narrower band of frequencies will be affected and
the tone will change markedly around the center frequency. If you
set a smaller value, a wider band of frequencies will be affected
and the tone will change gradually around the center frequency.
Settings: 0.1 to 12.0
NOTE
• If the LowShape or HighShape parameter has been set to
“shelving”, the corresponding width (Q) setting will be displayed
as “---” and modification will not be possible.
LowShape and HighShape
Use these parameters to set EQ types for the low and high fre-
quency bands, respectively.
Settings: shelving, peaking
• Shelving
Signals at all frequencies either above or below the specified
frequency will be boosted or cut.
• Peaking
Signals at frequencies in the vicinity of the center frequency
will be boosted or cut.
KIT/PAD
 List of Functions
Pad Control Type (PadCtrlType)
When a pad featuring a pad controller is connected to the
DTX700, this parameter can be used to assign a function to it.
Before making a setting, be sure to press the [F1] button (PAD)
and select the trigger input jack that the pad in question has been
plugged into.
Q=0.1
Q=12.0
Frequency (Hz)
Center frequency
EQ low EQ high
Gain
Center
frequency
Gain
Center
frequency
Frequency (Hz) Frequency (Hz)
Gain
Center frequency
Frequency (Hz)
For pad-related settings
KIT/PAD 1/3
off No function is assigned to the pad controller.
snares
By turning the pad controller, you can change the set-
tings of the SnaresOn/Off (Snare Wire On/Off) and
SnaresAdjust (Snare Wire Adjustment) parameters (also
from the Menu area’s Kit/Pad page), thus adjusting the
tightness of the snare wire. For example, turning the pad
controller counter-clockwise progressively loosens the
snare wire, ultimately removing it from the snare. Turning
the pad controller clockwise tightens the snare wire. If the
snare wire is in the removed condition, turn the pad con-
troller clockwise to bring it into contact with the snare.
tuning
By turning the pad controller, you can change the set-
ting of the Tune (Tuning) parameter from the Menu
area’s Kit/Voice page, thus adjusting the pitch of the
drum voice. For example, turning the pad controller
counter-clockwise lowers the pitch and vice-versa.
tempo
By turning the pad controller, you can adjust the song or
click-track tempo. Whenever you are doing so, the dis-
play will show the tempo setting.
filter
By turning the pad controller, you can change the set-
ting of the Filter parameter from the Menu area’s Kit/
Voice page, thus adjusting the tone of the drum voice.
For example, turning the pad controller counter-clock-
wise darkens the tone and vice-versa.
snares
On/Off
By turning the pad controller, you can switch the
SnaresOn/Off (Snare Wire On/Off) parameter (also from
the Menu area’s Kit/Pad page) from “off” to “on” and
vice-versa. For more details, refer to Internal Design of
the DTX700
(see page 3) .
Pad
PadCtrlType
HH Func
HH MIDI Ch
HH MIDI Type
SnaresOn/Off
SnaresAdjust
SnareBuzz
ResonanceLevel