Yamaha DTX700 - Manual (Page 49)

TRIGGER
DTX700 Reference Manual 49
w RejectLevel
Use this parameter to specify a level for preventing crosstalk from
the pad(s) indicated by
e . If the input level produced at current
pad (selected using [F1]) is lower than this level whenever the
pad(s) indicated by
e are struck, it will be treated as crosstalk
and no trigger signal will be generated. Although higher settings
are more effective in preventing crosstalk, they can also make it
difficult to play multiple pads at the same time.
Settings: 0% to 99%
e From
Use this parameter to specify a pad or group of pads causing
crosstalk in the current pad. You can also strike a pad to select it.
Settings: Snare, Tom1, Tom2, Tom3, Ride, Crash1, Crash2,
HiHat, Kick, Pad10, Pad11
NOTE
• When more than one pad is selected for the From parameter,
the name of the first one is indicated, followed by a “+” symbol.
 Setting Procedure
1. Select the pad to be set (i.e., the current pad) either by
striking it or by pressing the [F1] button (PAD) to open a
popup window and making a selection by turning the dial.
2.
Turn the dial to move the cursor to the row shown below
and press the dial.
The following popup window will appear.
: All selections are cleared.
: All pads are selected.
q indicates the name of the trigger input jack for the
selected checkbox.
w indicates the number of the trigger input jack.
3. Using the dial, move the cursor to the trigger input jack of
any pad causing crosstalk in the current pad. Press the dial
to select that pad. You can press again to deselect the pad.
4.
Press the [EXIT] button to return to the previous page.
q
w