Yamaha DTX700 - Manual (Page 42)

UTILITY
DTX700 Reference Manual 42
Sequencer Control (SeqCtrl)
Use this parameter to specify whether or not System Realtime
messages (i.e., FA Start, FB Continue, and FC Stop) will be sent
and received via MIDI.
Settings: off, in, out, in/out
NOTE
• If “start”, “continue”, or “stop” has been set for the MessageType
parameter from the Menu area’s Kit/MIDI/Assign page, the
SeqCtrl (Sequencer Control) setting will have no effect and the
corresponding message (i.e., FA Start, FB Continue, or FC
Stop) will be output.
MIDI Merge (Merge)
The MIDI Merge function allows you to mix MIDI messages
received via the [MIDI IN] connector with performance data pro-
duced by playing the DTX700, and to output this mixed MIDI
data via the [MIDI OUT] connector. Set this parameter to “on” to
enable the merging of MIDI messages in this way.
Settings: off, on
Channel 10 Receive (Rcv10ch)
Use this parameter to enable (“on”) or disable (“off”) the receipt
of MIDI messages sent by external devices on Channel 10. If set
to “off”, the internal tone generator will play voices on Channel
10 in response only to input from pads connected to the DTX700.
Settings: off, on
Program Change Receive (RcvPC)
Use this parameter to enable (“on”) or disable (“off”) the receipt
of MIDI Program Change messages. If set to “off”, voices will be
changed based only on drum-kit voice settings when a new kit is
selected. If you want voices on all MIDI channels to change in
line with song settings and in response to signals from external
MIDI devices, this parameter should be set to “on”.
Settings: off, on
Channel-10 Program Change Receive (RcvPC10ch)
Use this parameter to enable (“on”) or disable (“off”) the receipt
of MIDI Program Change messages sent on MIDI channel 10. If
you want kits to change in line with song settings or in response
to signals from external MIDI devices, this parameter should be
set to “on”. Note that this setting takes effect only when “on” is
also selected for the RcvPC (Program Change Receive) parame-
ter (on this page).
Settings: off, on
Polyphonic Aftertouch (PolyAfter)
Use this parameter to enable (“on”) or disable (“off”) the
exchange of polyphonic aftertouch with external MIDI devices.
Settings: off, on
Send Hi-hat Controller (SendHH)
Use this parameter to enable (“on”) or disable (“off”) the sending
of MIDI messages corresponding to continuous motion of a hi-
hat controller between the open and closed positions.
Settings: off, on
NOTE
• If “hi-hat” is selected for the HH Func (Hi-hat Function) param-
eter from the Menu area’s Kit/Pad page, MIDI messages will
be sent only when this parameter is set to “on”.
• If “MIDI” is selected for the HH Func (Hi-hat Function) parame-
ter from the Menu area’s Kit/Pad page, MIDI messages will
always be sent, regardless of whether this parameter is set to
“on” or “off”.
UTILITY/MIDI 2/3
off
System Realtime messages are neither sent nor
received.
in
System Realtime messages are received but not
sent.
out
System Realtime messages are sent but not
received.
in/out
System Realtime messages are sent and
received.
UTILITY/MIDI 3/3