Xerox 480 ST - Manual (Page 24)

Page 2 - 2 Xerox Document Centre System Administration Guide
How to set the Ethernet Speed
1. Enter the Tools pathway
a) Press the Access ( or ) button.
b) On the keypad enter 1111 or the current password. Press
the Enter button when finished. The Touch Screen will
be used for the remainder of the data entry, unless
instructed otherwise.
c) Press the Go to Tools button.
2. Set or Change the Network Connection Speed.
a) Wait for the screen to refresh and press the Connectivity
and Network Setup button.
b) Wait for the screen to refresh and press the Physical
Media button.
c) Press the Ethernet button.(If available.)
NOTE Auto-Sensing hubs may not arbitrate correctly with the Document
Centre when Auto is selected. If your hubs/concentrators support
the 100BaseT speed it is recommended you select 100Mbps in
Step d below. (Be sure your Ethernet cable is Category 5)
d) Select the desired Speed 10Mbps, 100Mbps, or Auto.
e) When finished with your changes press Save.
3. Press the Exit Tools button.
4. Wait a MINIMUM of 7 minutes for the printer to reset. The
Network Controller is being reset and initializing with the
new setup. When complete a Configuration Report will print.
a) Obtain the Configuration Report page from your
printer and verify that your settings have been retained.
5. Connect your Document Centre to the network with the
appropriate cabling.